18.07.2014, 08:35
(Dieser Beitrag wurde zuletzt bearbeitet: 18.07.2014, 08:41 von Kaffeestudio-Marc.)
Fehler 09 müsste ein Fehler im Heizsystem sein.
Somit folgende Möglichkeiten:
- NTC-Sensor abgefallen oder defekt
- Verkablung des Sensor zur Elektronik
- Heizung defekt --> sollte ca. 45 Ohm haben
- Ansonsten kann es wenn es das andere nicht ist, an der Leitungselektronik liegen:
Heikreislauf: Triac, Optokoppler und/oder Z-Dioden.
Das war so das was ich im Internet gefunden habe.
Je nach dem Alter des Gerätes kann es auch sein, dass man ein neueres Gerät zum Spezialpreis angeboten bekommt. Vielleicht mal mit Krups in Kontakt treten, wenn es mit der Reparatur nicht klappen sollte und es ein Nachfolger sein soll.
__________________________________________________
english:
Error 09 must be a mistake in the heating system to be.
Thus the following options:
- NTC sensor dropped or damaged
- Cabling of the sensor to the electronics
- Heating defective -> should have 45 ohm
- Otherwise, it can if it is not the other, lie at the line electronics:
Heikreislauf: triac, optocoupler and / or Zener diodes.
That was what I found on the internet.
Depending on the age of the device, it may also be that you get offered at a special price a newer device. Maybe times contact Krups in contact if it does not work with the repair and it should be a successor.
Somit folgende Möglichkeiten:
- NTC-Sensor abgefallen oder defekt
- Verkablung des Sensor zur Elektronik
- Heizung defekt --> sollte ca. 45 Ohm haben
- Ansonsten kann es wenn es das andere nicht ist, an der Leitungselektronik liegen:
Heikreislauf: Triac, Optokoppler und/oder Z-Dioden.
Das war so das was ich im Internet gefunden habe.
Je nach dem Alter des Gerätes kann es auch sein, dass man ein neueres Gerät zum Spezialpreis angeboten bekommt. Vielleicht mal mit Krups in Kontakt treten, wenn es mit der Reparatur nicht klappen sollte und es ein Nachfolger sein soll.
__________________________________________________
english:
Error 09 must be a mistake in the heating system to be.
Thus the following options:
- NTC sensor dropped or damaged
- Cabling of the sensor to the electronics
- Heating defective -> should have 45 ohm
- Otherwise, it can if it is not the other, lie at the line electronics:
Heikreislauf: triac, optocoupler and / or Zener diodes.
That was what I found on the internet.
Depending on the age of the device, it may also be that you get offered at a special price a newer device. Maybe times contact Krups in contact if it does not work with the repair and it should be a successor.
"The monsters aren't living under your bed
'Cause they are the voices in your head"
- Falling in Reverse -
'Cause they are the voices in your head"
- Falling in Reverse -