12.10.2015, 09:51
(12.10.2015, 08:23)Jurist schrieb: I try to explain. From the water map you can see that "D" is the outgoing part. To test the pump you must switch on the mashine and let the pump working. Water must come out with pressure. When it only drips the pump is broken. Hose must be removed.
Anther candidate is the Auslaufventil, remove the black cap and have a look inside. Be aware there is a Spring who can jump away...
Jurist!
Thanks! I'm at work right now so I cannot check again. I took the safe route (I hope) and ordered some parts from BND this morning like, the new version of the pump, thermostat for the pump, rubber holders for the pump etc. as well as other parts that is good to have on the shelf like drainage ventil, O-rings for drainage ventil, thermoblock and brew group.
I'll update you on the progress when parts arrived and have been changed, thanks a lot so far! :-)
